Back to Blog
Voxel tycoon junctions7/24/2023 ![]() ![]() Here you can see the intersection completed.Connect this to the exit rail of the rampĬompleted Intersection Completed Intersection Without Signals.On the 45° curve of the new long rail, place rail parallel to the exit ramp.Step 10: Build Outer Rails Step 10: Build Outer Rails Connect a rail section from the inner curve section to the outer rail.Step 9: Build Outer Rails Step 9: Build Outer Rails Looking at the top left inner curve, from 45° connect rail down to the left top rail.Extend the rails from the outer ramps outwards and also place a parallel section of ramp next to it.Step 8: Build Inner Rails Step 8: Build Inner Rails The screenshot below shows the tunnels created.Move the cursor to the section of the rail on the other side of the 2x5 gap a tunnel will appear (no need to adjust cursor height).Using the Lay rails tool, start off by clicking the rail at one side and then press the T key to change to tunnel mode.Now it's time to connect a tunnel between the two low sections of the ramps, between the 2x5 gap.Step 7: Create Tunnels Step 7: Create Tunnels Lay rail from the bottom 2x2 hole and bring it up to the ground level.Step 6: Place Rail Ramps Step 6: Place Rail Ramps Lower the terrain 2x2 for a depth of 3, leaving a gap of 5 between the existing hole and new hole.Step 5: Lower Terrain Step 5: Lower Terrain You may need to build a small section of rail at top of each ramp first, you can see the ones without the corners had this added after removing the positional markers.In the screenshot I am bringing the rail to the right and then parallel to the next rail ramp.Remove the positional markers as they are no longer required.Step 4: Inner Rail Corner Step 4: Inner Rail Corner Use the Lay rails tool and start from the bottom 2x2 hole and bring it up to the 1x2 positional marker opposite.Step 3: Place Rail Ramps Step 3: Place Rail Ramps Lower the terrain 2x2 for a depth of 3, looking at the top left corner this is under the 1x2 marker which was 1 down.Step 2: Lower Terrain Step 2: Lower Terrain Then place 1x2 markers in each corner, looking at the top left corner leave a gap of 1 down and a gap of 2 right.This begins with a 15 x 15 grid, this is the four corner markers.Left Hand Variant Step 1: Place Positional Markers Step 1: Place Positional Markers Below you will find detailed steps to build the left hand variation of this intersection and then following that is the screenshots for the right hand variant. This is a 4 Way Intersection taken from and is inspired by Fenderson#7615 on Discord. ![]()
0 Comments
Read More
Leave a Reply. |